JUMBO LIFT 3500 NT short

The hydraulic double scissor lift JUMBO LIFT 3500 NT short with a capacity of 3500 kg is the perfect all-round lift for car workshops where speed, flexibility and reliability are in demand. With its small space requirement, its high lifting height of 2000 mm, the length-adjustable platforms and the flat design, it is the lift that no professional car workshop should be without. Whether for tyre changes, oil changes, work on the engine or the check-in inspection, for low-lying sports cars, SUVs or vans, the JUMBO LIFT 3500 NT short is ready to lift and lifted at lightning speed. The drive-on ramps can be unlocked and locked by one-hand operation in order to extend or shorten the platform. The Jumbo Lift 3500 NT kurz is developed and manufactured by Nussbaum at its main plant in Kehl-Bodersweier in Baden-Württemberg.

• Lifting time: 35 seconds
• Capacity: 3500 kg
• Effective lifting height of 2000 mm
• Extremely flat construction: Drive-on height of only 105 mm
• Length-adjustable mounting - drive-on ramps can be locked and unlocked by one-hand operation
• Flexible mounting: Adjustable width, no compressed air access required
• 360° access
• Two possible installation types: above ground (1) - inground (2)
• Three times guaranteed quality: Power unit, hydraulic cylinder and the complete lifting platform are tested before dispatch.
• Developed and manufactured in Germany
• Recommended by BMW (for similar lifts)

All hydraulic JUMBO LIFTS are equipped with two redundant hydraulic circuits as standard: Nussbaum's patented NT hydraulic technology is complemented by HyperFlow® technology, introduced in 2016 and unique worldwide. HyperFlow® automatically balances the pressure of the hydraulic circuits at each full stroke. There is no need for manual compensation or maintenance. The JUMBO LIFT 3500 NT short is not only safe, but also exceptionally flexible and can be installed in different installation widths as required. 

The Jumbo Lift 3500 NT kurz requires no compressed air at all. The four hydraulic cylinders require very little energy. The low power consumption, the continuous automatic compensation of the hydraulic circuits by the HyperFlow® system and the low maintenance requirements, also thanks to the reduced number of moving parts, reduce running costs. The operating lever "Nussbaum Commander" is attached to the power unit integrated in a metal housing. The control unit is connected to the lift only by the hydraulic hoses and can be positioned freely around the lift. The hydraulic hoses can be mounted on the workshop floor or in a protective metal housing on the floor as required. The double scissors are welded in Nussbaum's own state-of-the-art welding facilities, shot-peened and subsequently grau powder-coated. Your lifting platform is protected against dirt and weather for a long time.

Scope of delivery

Lift with powder-coated platform, CE-STOP, compact underoil motor, can be installed on left or right side, length of hydraulic lines 1 m, 1 set = 4 pieces superductile polymer supports 50 x 150 x 340 mm

Installation requirements

Foundation (min. 160mm / quality min. C20/25), 12 dowels BM10-15/70/40, (depending on foundation, see manual), Hydraulic Oil HLP ISO 32, Volume ca. 13 liter, eletric connection 3 PH, N + PE, 400 V, 50 Hz, 16 Amp. slow fuse, Unloading