POWER LIFT HL 2.30 NT DT

The hydraulic 2-post lift Power Lift HL 2.30 NT DT with a load capacity of 3000 kg and asymmetrical double telescopic lifting arms is the ideal lift for the demanding car repair shop with a high work volume. With the world's fastest lifting and lowering times for hydraulic lifts in their weight class and minimum maintenance requirements (no synchronization ropes, no pulleys, no ratchet) it is the ideal lift for daily continuous use in a constantly busy motor vehicle workshop. The Power Lift HL 2.30 NT DT is equipped as standard with the patented Nussbaum NT and HyperFlow® technologies and has been developed and manufactured by Nussbaum since its ; market launch in 2014 in Kehl-Bodersweier in Baden-Württemberg .

• Lifting time: 20 seconds / Lowering time [AttributeShortCode,attribute=Lowering time,attributeid=62] seconds
• Load capacity: 3000 kg
• Adjustable in width and height (with optional column extension)
• Compressed air connection and 220 V socket integrated in column
• Recommended by Mercedes-Benz and BMW (for similar lifts HL 2.35 NT DT MB and HL 2.40 NT BMW)
• High quality: Every power unit and every hydraulic cylinder is tested before shipment
• Developed and manufactured in Germany

The HL NT series is the result of over 40 years of experience in the manufacture and development of high-quality automotive lifts Made in Germany. With specially developed, in-house technologies, we are the only lift manufacturer in the world that can provide you with a precise, variable lowering speed and an always perfect synchronisation without manual maintenance effort . The ergonomic, stepless operating lever Nussbaum-Commander enables sensitive lowering and allows the user to change and correct positions in the twinkling of an eye, all with maximum safety.

The Power Lift HL 2.30 NT DT is not only safe, but also exceptionally flexible and can be adapted to a wide range of workshop sizes and configurations.Their base frame-free design, adjustable in width and height, enables a wide range of installation combinations and variants:  With a minimum height of 4022  mm and a maximum height of 4904 mm thanks to the optional riser pipe extensions the Power Lift HL 2.30 NT DT can be used both in workshops with low ceiling heights and to lift the underbody of high vehicles such as vans and vans to the ideal working height for you (Tip: You need a hydraulic lift for an even lower ceiling height? Then the Power Lift HL 2.30 NT RH RH DT is just right for you).

The pulling hydraulic cylinders protect the hydraulic circuit even during intensive use and require very little energy. The low power consumption, the consistent automatic compensation of the hydraulic circuits by the HyperFlow® system and low maintenance costs, also thanks to the reduced number of moving parts, reduce running costs. The pump unit integrated in a sound-absorbing metal housing is mounted on the control column and easily accessible for maintenance work. A compressed air connection and a 220 V socket are integrated in the control column. The arms and columns made of high-quality steel are welded in Nussbaum's own state-of-the-art welding facilities, shot-peened and subsequently blau powder-coated. Your lift is thus protected against dirt and weather in the long term.

The design and the processing of the Power Lift HL 2.30 NT DT give it an elegant overall appearance, which also allows your workshop to appear in the best light in direct customer contact.

Scope of delivery

Lift with asymmetrical, telescopic arms, four turntables fixed in the arm, energy set: E-Set (230 V/ compressed air) integrated in the operating column

Installation requirements

Foundation 200mm C20/25 standard reinforcement, 16 dowels BM12-20/80/40 (depending on foundation, see manual), eletric connection 3 PH, N + PE, 400 V, 50 Hz, 16 Amp. slow fuse, Compressed air connection for energy set, Hydraulic Oil HLP32 ca. 10l, Unloading